Model Parts Guide
Hitachi ZX200 Bucket Teeth and Adapter Inquiry Guide
A model-focused wear-parts RFQ guide that avoids assuming every ZX200 bucket uses the same tooth system.
Quick answer
For Hitachi ZX200 bucket teeth, confirm the exact installed tooth-and-adapter system because buckets and previous replacements can differ. Send the full ZX200 model and serial number, bucket size, old tooth and adapter references, tooth pocket and side-profile photos, pin and retainer arrangement, job-site material and quantity. State whether you need teeth only, hardware, adapters or a complete bucket set.
Do not treat ZX200 as one universal tooth system
The machine model identifies the excavator, not necessarily the bucket manufacturer or tooth system. Standard, rock, heavy-duty and replacement buckets can carry different adapters.
Use the old tooth and adapter together as the primary physical reference, supported by the machine and bucket information.
- Full ZX200 model suffix and serial
- Bucket width and application
- Old tooth and adapter casting marks
- Tooth pocket and adapter nose profile
- Pin and retainer orientation
Match the profile to the working condition
Soil, clay, sand and rock place different demands on penetration and wear resistance. Describe the dominant material, impact level and current wear pattern.
If the existing tooth wears unevenly, also inspect adapter alignment, bucket edge condition and operating practice before selecting a heavier profile.
- General excavation
- Compacted material
- Abrasive sand or gravel
- Quarry or rock impact
- Monthly hours and replacement interval
Define the complete ZX200 wear-parts order
Count teeth and identify any left, right or center pieces. Inspect adapters, pins and retainers so the delivered order does not stop at the job site because one hardware item is missing.
For planned stock, separate immediate bucket repair from future replacement quantity and provide the delivery destination.
- Tooth quantity and position
- Adapters requiring replacement
- Pins and retainers
- Bucket-edge hardware
- Immediate set versus reserve stock
ZX200 wear-parts RFQ fields
| Field | Evidence | Purpose |
|---|---|---|
| Machine | Full model and serial plate | Records the excavator application |
| Bucket | Width, type and edge photos | Identifies non-standard bucket possibilities |
| Tooth system | Tooth, adapter, pin and casting photos | Confirms physical compatibility |
| Application | Material and wear pattern | Supports profile selection |
| Scope | Line-by-line teeth and hardware quantity | Prevents incomplete delivery |
Buyer checklist before requesting a quote
- ZX200 suffix and serial are included
- Bucket type and size are described
- Old tooth and adapter are photographed together
- Casting marks and pin system are visible
- Working material is stated
- Teeth, adapters, pins and retainers have separate quantities
Frequently asked questions
Are all Hitachi ZX200 bucket teeth interchangeable?
No. Different buckets and tooth systems can be installed, so the adapter and locking system must be confirmed.
Can I select the tooth profile from soil type alone?
Soil is important, but the installed tooth system, bucket, impact and wear pattern must also be considered.
When should adapters be replaced?
Inspect the adapter nose for wear, cracks and loss of retention; a worn adapter can make a new tooth loose.